Ads
related to: dana 44 ring gear spacer 2mm bolt pattern
Search results
Results From The WOW.Com Content Network
Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.
The Dana 18 is a gear driven part-time transfer case. [2] Both the front and rear output shafts are offset towards the passenger side of the vehicle. Drive modes offered include 2-wheel high, part-time 4-wheel high, and part-time 4-wheel Low. All Dana 18 cases are cast iron and use the "Texas" bolt pattern with five bolts holding on the ...
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60 .
Dana Incorporated is an American supplier of axles, driveshafts, and electrodynamic, thermal, sealing, and digital equipment for conventional, hybrid, and electric-powered vehicles. The company's products and services are aimed at the light vehicle, commercial vehicle, and off-highway equipment markets.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Dana 50 has a "50" cast into the housing and is regarded to have more strength than a Dana 44, but not as much as a Dana 60. It was only produced in a reverse cut gear set aka a high pinion. The Dana 50 was made as a solid axle and as a Twin Traction Beam (TTB) which pivots in the center allowing the wheels to move independently of each ...
The Dana 53 first appeared in the late 1940s and is much like a Dana 60. Although all Dana 53s are semi-floating, rear axles, 9.25" ring gear diameter. It was used as OEM in 1960s full-size (C-body) Chrysler passenger cars equipped with the 440 CID engine. The Dana 53 was phased out in the late 1960s, replaced by the Dana 60.