Ad
related to: random antenna wiring diagram chart printable free images
Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The rhombic antenna is a directional wire antenna used on MF and HF bands for shortwave reception. The antenna consists of a wire suspended above the ground in the shape of a rhombus , terminated at one end by a resistor equal the the wire's characteristic impedance, about 400 to 600 ohms, and at the other end connected to the feedline to the ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [14] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
This file contains additional information, probably added from the digital camera or scanner used to create or digitize it. If the file has been modified from its original state, some details may not fully reflect the modified file.
English: The image gives six circuit diagrams (schematics) for balanced line antenna tuners of the tuned-transformer type, discussed in the Wikipedia article "Antenna Tuner" or "ATU". It is an edited version of the original by JNRSTANLEY uploaded 2014-10-15.
English: Diagram of a ground plane antenna, a common omnidirectional monopole antenna used at VHF and UHF frequencies. It consists of a vertical whip antenna one quarter wavelength long, with 3 or 4 quarter wave rods extending from the base electrically connected to the ground side of the transmission line.
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.