Search results
Results From The WOW.Com Content Network
The Pattern 1907 bayonet was supplied with a simple leather scabbard fitted with a steel top-mount and chape, and usually carried from the belt by a simple frog. The Pattern 1907 bayonet attaches to the SMLE by a boss located below the barrel on the nose of the rifle and a mortise groove on the pommel of the bayonet. [2] [4]
The 1908 pattern web equipment was the main equipment with which the British and Imperial armies fought the First World War. [8] The inability of the Mills factory to keep up with demand led to the introduction of a leather version, the 1914 Pattern Leather Equipment , which was intended for training and second line troops, but often found its ...
The M1910 scabbard was covered in canvas with a leather tip to prevent the blade tip from tearing the material. A wire hook that engaged grommets on the cartridge belt replaced the belt-hanger. The M1910 scabbard was the primary scabbard used during the World War I. Earlier M1905 scabbards were modified by replacing the belt-hanger with a belt ...
The No. 4 bayonet was created to replace the current bayonet at the time in service which was the World War I vintage Pattern 1907 bayonet. [2] It was the result of the British search for a new bayonet to replace the Pattern 1907 which began just after World War I which came to the conclusion around the beginning of World War II that the best replacement for the pattern 1907 bayonet would be a ...
An elaborate Celtic scabbard of 1-200 AD, in two colours of bronze 1916 Leather Scabbard for a saddle lever-action rifle of Jack Peters, a ranch hand that worked on the Grant-Kohrs Ranch, in Powell County, Montana. A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons.
A sword bayonet design, the M1917 bayonet design was based on the British Pattern 1913 bayonet, itself derived from the Pattern 1907 bayonet, which incorporated a long 17 in (43 cm) blade. While designed primarily for the M1917 rifle, the bayonet was fitted for use on all the "trench" shotguns at the time. The M1917 bayonet, being a direct copy ...
The scabbard was brown leather with a brass chape and frog hook. Soon after the Admiralty took over the Coastguard cutlass was withdrawn and standard navy pattern weapons issued. The hilts of the Coastguard cutlasses were reused by the War Department; mounted to straight blades they were issued to privates of the Army Hospital Corps from 1857.
The scabbard was made of steel, hanging from a leather strap, and was 22.7 cm long. A total of 101750 [27] was manufactured by Kongsberg Våpenfabrikk, Husqvarna and Steyr. Bayonet M/1912 was constructed during the development of the "short rifle" that became the M1912 carbine. It was significantly longer than the M/1894, to maintain the "reach ...