Ads
related to: 261 impactool 3 4 drive ratchet set with 2 piece steel car ramps
Search results
Results From The WOW.Com Content Network
Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
Impact driver guide set with bits. It is often used by mechanics to loosen larger screws, bolts and nuts that are corrosively "frozen" or over-torqued. [1] The direction can also be reversed for situations where screws have to be tightened with torque greater than a screwdriver can reasonably provide.
The company began as Moore Drop Forging Company in Springfield, Massachusetts in 1900 [1] or 1901. [2] In 1938 Moore became a vendor for Sears Roebuck. [1] In 1967, Moore Drop Forging was acquired by Eastern Stainless Steel Corporation, a manufacturer of stainless and specialty steel. Easco continued the Craftsman contract with Sears.
A 1/2" drive pistol-grip air impact wrench. An impact wrench (also known as an impactor, impact gun, air wrench, air gun, rattle gun, torque gun, windy gun) is a socket wrench power tool designed to deliver high torque output with minimal exertion by the user, by storing energy in a rotating mass, then delivering it suddenly to the output shaft.
A ratchet consists of a round gear or a linear rack with teeth, and a pivoting, spring-loaded finger called a pawl (or click, in clocks and watches [1] [2]) that engages the teeth. The teeth are uniform but are usually asymmetrical , with each tooth having a moderate slope on one edge and a much steeper slope on the other edge.