Ads
related to: difference between 2 and 3 wire submersible pump test
Search results
Results From The WOW.Com Content Network
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
3: Weather-resistant. Protects against falling dirt and windblown dust, against weather hazards such as rain, sleet and snow, and is undamaged by the formation of ice. Used outdoors on ship docks, in construction work, and in tunnels and subways. 3R: As 3, but omits protection against windblown dust. 3S: As 3, but also operable when laden with ice.
An insulation resistance test (IR test) measures the electrical resistance of insulation by applying a voltage between two locations, and measuring the resultant current flow. Proper safety precautions must be taken when doing this test, such as exclusion zones, making sure no wires are exposed, and personal protective equipment is worn.
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.
Three classes of submersible pumps exist: Smaller submersible pumps, used in domestic and light commercial applications, normally handle up to 55 millimetres (2.2 in) spherical solids and range from 0.75 to 2.2 kilowatts (1.01 to 2.95 hp). Larger submersible pumps, handle 65 millimetres (2.6 in) and larger solids and normally have a minimum of ...
Pumps being used to dewater a spillway at Baldhill Dam. Dewatering / d iː ˈ w ɔː t ər ɪ ŋ / is the removal of water from a location. This may be done by wet classification, centrifugation, filtration, or similar solid-liquid separation processes, such as removal of residual liquid from a filter cake by a filter press as part of various industrial processes.
The thermodynamic method takes advantage of this fact, and precisely measures the temperature difference across a pump to calculate the pump's efficiency. Pressure measurements are used to calculate the head of the pump, and a power meter is used to measure input power to the pump.