Search results
Results From The WOW.Com Content Network
A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor [1]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark.
A common dual dimmer module used in stage lighting A dimmer. A dimmer is a device connected to a light fixture and used to lower the brightness of the light.By changing the voltage waveform applied to the lamp, it is possible to lower the intensity of the light output.
Adjusting the brightness of light emitted by a light source is then merely a matter of setting at what voltage (or phase) in the AC half-cycle the dimmer begins to provide electric current to the light source (e.g. by using an electronic switch such as a triac). In this case the PWM duty cycle is the ratio of the conduction time to the duration ...
If no current/voltage is applied to the gate lead, the TRIAC switches off. On the other hand, if the trigger voltage is applied to the gate lead, the TRIAC switches on. TRIACs are suitable for light-dimming circuits, phase-control circuits, AC power-switching circuits, AC motor control circuits, etc.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
For example, a light dimmer uses a potentiometer to control the switching of a TRIAC and so indirectly to control the brightness of lamps. Preset potentiometers are widely used throughout electronics wherever adjustments must be made during manufacturing or servicing.
If the semiconductor is translucent, the junction becomes the source of light, thus becoming a light-emitting diode. I-V diagram for a diode. An LED begins to emit light when more than 2 or 3 volts is applied in the forward direction.
Compared to a rheostat-based circuit, the use of a thyristor greatly increases efficiency, as far less waste heat is generated. Dimming lights with a solid state dimmer also reduces total power draw, unlike rheostat dimmers. Spira's design (and most modern dimmers) rely on the use of AC power, and on the characteristics of incandescent lights.