Ads
related to: vacuum tube rectifier schematic
Search results
Results From The WOW.Com Content Network
Later thermionic vacuum tubes, mostly miniature style, some with top cap connections for higher voltages. A vacuum tube, electron tube, [1] [2] [3] [thermionic] valve (British usage), or tube (North America) [4] is a device that controls electric current flow in a high vacuum between electrodes to which an electric potential difference has been applied.
The first vacuum tube diodes designed for rectifier application in power supply circuits were introduced in April 1915 by Saul Dushman of General Electric. [2] [3] With the introduction of semiconductor electronics, vacuum tube rectifiers became obsolete, except for some enthusiasts of vacuum tube audio equipment.
U – High-vacuum half-wave rectifier; UU – High-vacuum full-wave rectifier; Number: Sequentially assigned number Examples: Note: "AC/"-series receiver tubes are listed under other letter tubes - AC/ 6C10 (6CU7/ECH42) – Triode/hexode frequency converter, Rimlock base; 6F22 (6267/EF86) – Low-noise A.F. pentode, noval base
Schematic symbol used in circuit diagrams for a vacuum tube, showing control grid. The control grid is an electrode used in amplifying thermionic valves (vacuum tubes) such as the triode, tetrode and pentode, used to control the flow of electrons from the cathode to the anode (plate) electrode. The control grid usually consists of a cylindrical ...
In very early vacuum tube television sets, the EHT was derived directly from a high voltage winding on the mains transformer using a half wave rectifier.In later television sets, the EHT supply was invariably generated by rectifying the flyback pulses from the scanning circuitry rather than directly from the mains supply (a practice that survived the transition to transistor circuits).
The 866 is a mercury vapor half-wave rectifier intended for high-voltage applications. The voltage drop is approximately 15 volts up to 150 Hz. To avoid unwanted shorts the tube must be operated in a vertical position and the filament preheated for at least 30 seconds before applying the plate voltage.
Mercury rectifier on display in the Beromünster AM transmitter in Switzerland, before being decommissioned.Three-phase full-wave rectifier with six anodes. A mercury-arc valve or mercury-vapor rectifier or (UK) mercury-arc rectifier [1] [2] is a type of electrical rectifier used for converting high-voltage or high-current alternating current (AC) into direct current (DC).
So-called "All American Five" vacuum tube radio receivers used a power supply that could work on either AC or DC. An AC/DC receiver design is a style of power supply of vacuum tube radio or television receivers that eliminated the bulky and expensive mains transformer. A side-effect of the design was that the receiver could in principle operate ...