Search results
Results From The WOW.Com Content Network
For a peel ply, a thin, woven piece of material is applied to the adherend during fabrication. [9] Because the material is woven, it will leave a torturous surface when removed, which will improve bonding by mechanical interlocking. [6] Prior to adhesive bonding, the woven material acts to protect the surface of the adherend from contaminates.
To incorporate the effect of adhesion in Hertzian contact, Johnson, Kendall, and Roberts [5] formulated the JKR theory of adhesive contact using a balance between the stored elastic energy and the loss in surface energy. The JKR model considers the effect of contact pressure and adhesion only inside the area of contact.
Likewise, contaminants, especially those which, due to their low surface tension, counteract wetting by the adhesive (for example, oils, release agents, etc.) hinder the adhesion interaction. Contaminants form, as it were, a barrier between the adhesive and the substrate which cannot be bridged by the adhesion forces due to their short reach.
The distribution of the shear stress is described by the Carter-Fromm solution. It consists of an adhesion area at the leading edge of the contact area and a slip area at the trailing edge. The length of the adhesion area is denoted ′. Further the adhesion coordinate is introduced by ′ = + ′.
STM image of a quinacridone adsorbate.The self-assembled supramolecular chains of the organic semiconductor are adsorbed on a graphite surface.. Surface science is the study of physical and chemical phenomena that occur at the interface of two phases, including solid–liquid interfaces, solid–gas interfaces, solid–vacuum interfaces, and liquid–gas interfaces.
To fix peeling paint, begin by removing any loose sections. "It’s always best to remove any paint that does not have good adhesion," says Fiorilli. Fix Wall Imperfections
In adhesion tests per ASTM D4541, in which an aluminum stud is bonded to the test surface and the stud is pulled in the direction normal to the surface, both surfaces of the failure interface were analyzed by X-ray photoelectron spectroscopy (XPS). F/C ratio was used as an indicator of the failure mode: F/C of zero corresponds to failure in the ...
Note 1: Adhesion requires energy that can come from chemical and/or physical linkages, the latter being reversible when enough energy is applied. Note 2: In biology, adhesion reflects the behavior of cells shortly after contact to the surface. Note 3: In surgery, adhesion is used when two tissues fuse unexpectedly. [1]