Ads
related to: diamond size 5/8 x 16 anchor bolts chart
Search results
Results From The WOW.Com Content Network
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
The major diameter still extends to within 1 / 8 H of the theoretical sharp V, but the total depth of the thread is reduced 4% from 5 / 8 H = 5 / 8 cos(30°) P ≈ 0.541P to 0.52P. [5] This increases the amount of the theoretical sharp V which is cut off at the minor diameter by 10% from 0.25H to 7 / 8 − 0. ...
Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats definition is the common standard today, and has been for many decades.
A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
The Thury thread form had the crests rounded at 1 / 6 p and the roots rounded at 1 / 5 p so the thread angle was close to 47.5° but not exactly. This was simplified in the BA thread definition by defining the thread angle to be 47.5° exactly and the thread form to be symmetrical with a depth of 3 / 5 p.