Search results
Results From The WOW.Com Content Network
An SSTV repeater is an amateur radio repeater station that relays slow-scan television signals. A typical SSTV repeater is equipped with a HF or VHF transceiver and a computer with a sound card, which serves as a demodulator/modulator of SSTV signals. SSTV repeaters are used by amateur radio operators for exchanging pictures.
The radio's COS (carrier operated squelch) and PTT lines must be available to the IRLP board. Additionally, courtesy tones, hang time, and node IDs must not be transmitted over the VoIP link. This can easily be accomplished using CTCSS on the repeater transmitter that follows the COS of the receiver.
WWVB's Colorado location makes the signal weakest on the U.S. east coast, where urban density also produces considerable interference. In 2009, NIST raised the possibility of adding a second time code transmitter, on the east coast, to improve signal reception there and provide a certain amount of robustness to the overall system should weather or other causes render one transmitter site ...
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]
APRS packets are transmitted for all other stations to hear and use. Packet repeaters, called digipeaters, form the backbone of the APRS system, and use store and forward technology to retransmit packets. All stations operate on the same radio channel, and packets move through the network from digipeater to digipeater, propagating outward from ...
NHK digital television, KRY, TYS and YAB transmitter in Iwakuni. A broadcast relay station, also known as a satellite station, relay transmitter, broadcast translator (U.S.), re-broadcaster (Canada), repeater (two-way radio) or complementary station (Mexico), is a broadcast transmitter which repeats (or transponds) the signal of a radio or television station to an area not covered by the ...
A typical microwave repeater link setup, this one located near Salt Lake City, Utah, USA(removed in 2013) Operation principle. A passive repeater or passive radio link deflection, is a reflective or sometimes refractive panel or other object that assists in closing a radio or microwave link, in places where an obstacle in the signal path blocks any direct, line of sight communication.
Since 10 meters can frequently open up to propagate globally, most 10-meter repeaters use a CTCSS sub-audible access tone. 16 kHz-wide signals with 5 kHz deviation is normal in this band. 8 kHz-wide signals with 2.5 kHz deviation can also be found. 2.5kHz deviation is mandated by FCC rules below 29.0 MHz.