Ads
related to: check valve controls for small spaces in water tank
Search results
Results From The WOW.Com Content Network
A swing check valve (or tilting disc check valve) is a check valve in which the disc, the movable part to block the flow, swings on a hinge or trunnion, either onto the seat to block reverse flow or off the seat to allow forward flow. The seat opening cross-section may be perpendicular to the centerline between the two ports or at an angle.
Conventional control valves can typically control flow or pressure in the 20% to 80% range. Additionally, unlike conventional control valves the sleeve valve increases flow incrementally, i.e. 10% increase in stroke leads to a 10% increase in flow. Sleeve valves are adaptive to system or consumer requirements. The sleeve valve is designed to ...
Air-actuated control valves each with a 4–20 mA "I to P" converter integral to a valve positioner. In this example each positioner is comparing the valve steam travel against control signal, and applying any correction. The opening or closing of automatic control valves is usually done by electrical, hydraulic or pneumatic actuators. Normally ...
A float switch is a type of level sensor, a device used to detect the level of liquid within a tank. The switch may be used to control a pump, as an indicator, an alarm, or to control other devices. One type of float switch uses a mercury switch inside a hinged float. Another common type is a float that raises a rod to actuate a microswitch.
A level control valve or altitude control valve is a type of valve that automatically responds to changes in the height of a liquid in some storage system. A common example is the set of ballcocks in a flush toilet, where each stage of the flush cycle is actuated by the emptying or filling of the tank. Another example is in reservoirs and other ...
Because certain combinations of check valve failure and/or system backpressure cause the relief valve to discharge, the device must be mounted in a location where the drain will not become flooded. An example of where backflow would harm the water supply is the use of well washing devices inside underground sewerage pumping stations.