Search results
Results From The WOW.Com Content Network
The difference is that NAND logical gates are used in the gated D latch, while SR NAND latches are used in the positive-edge-triggered D flip-flop. The role of these latches is to "lock" the active output producing low voltage (a logical zero); thus the positive-edge-triggered D flip-flop can also be thought of as a gated D latch with latched ...
The initial formulation of the retiming problem as described by Leiserson and Saxe is as follows. Given a directed graph:= (,) whose vertices represent logic gates or combinational delay elements in a circuit, assume there is a directed edge := (,) between two elements that are connected directly or through one or more registers.
Modbus uses a master device to initiate connection requests to slave devices. An edge-triggered flip-flop can be created by arranging two gated latches in a master–slave configuration. It is so named because the master latch controls the slave latch's value and forces the slave latch to hold its value, as the slave latch always copies its new ...
When the input is below a different (lower) chosen threshold the output is low, and when the input is between the two levels the output retains its value. This dual threshold action is called hysteresis and implies that the Schmitt trigger possesses memory and can act as a bistable multivibrator (latch or flip-flop). There is a close relation ...
A network interface controller (NIC, also known as a network interface card, [3] network adapter, LAN adapter and physical network interface [4]) is a computer hardware component that connects a computer to a computer network. [5] Early network interface controllers were commonly implemented on expansion cards that plugged into a computer bus.
The difference of principal between CML and ECL as a link technology is the output impedance of the driver stage: the emitter follower of ECL has a low resistance of around 5 Ω whereas CML connects to the drains of the driving transistors, that have a high impedance, and so the impedance of the pull up/down network (typically 50 Ω resistive ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Transistors are used as switches to pass logic levels between nodes of a circuit, instead of as switches connected directly to supply voltages. [1] This reduces the number of active devices, but has the disadvantage that the difference of the voltage between high and low logic levels decreases at each stage (since pass transistors have some ...