Ad
related to: what is a vortex vector machine and how does it work for beginners step by step
Search results
Results From The WOW.Com Content Network
The Vortex lattice method, (VLM), is a numerical method used in computational fluid dynamics, mainly in the early stages of aircraft design and in aerodynamic education at university level. The VLM models the lifting surfaces, such as a wing , of an aircraft as an infinitely thin sheet of discrete vortices to compute lift and induced drag .
In a working vortex layer, the modulus of the averaged magnetic induction vector reaches values of 0.2 T and lags behind the external field strength by a certain phase angle. [13] The specific power of the vortex layer in various modes for these devices ranges from 0.1 to 1.5 kW per cubic decimeter of the working area. [13]
A vortex mixer, or vortexer, is a simple device used commonly in laboratories to mix small vials of liquid. It consists of an electric motor with the drive shaft oriented vertically and attached to a cupped rubber piece mounted slightly off-center.
A vortex tube is the surface in the continuum formed by all vortex lines passing through a given (reducible) closed curve in the continuum. The 'strength' of a vortex tube (also called vortex flux ) [ 10 ] is the integral of the vorticity across a cross-section of the tube, and is the same everywhere along the tube (because vorticity has zero ...
The Lambda2 method, or Lambda2 vortex criterion, is a vortex core line detection algorithm that can adequately identify vortices from a three-dimensional fluid velocity field. [1] The Lambda2 method is Galilean invariant , which means it produces the same results when a uniform velocity field is added to the existing velocity field or when the ...
A vortex generator (VG) is an aerodynamic device, consisting of a small vane usually attached to a lifting surface (or airfoil, such as an aircraft wing) [1] or a rotor blade of a wind turbine. [2] VGs may also be attached to some part of an aerodynamic vehicle such as an aircraft fuselage or a car.
A vortex flow might also be combined with a radial or axial flow pattern. In that case the streamlines and pathlines are not closed curves but spirals or helices, respectively. This is the case in tornadoes and in drain whirlpools. A vortex with helical streamlines is said to be solenoidal.
The small time behavior of the flow is then found through simplification of the incompressible Navier–Stokes equations using the initial flow to give a step-by-step solution as time progresses. An exact solution in two spatial dimensions is known, and is presented below. Animation of a Taylor-Green Vortex using colour coded Lagrangian tracers