Ad
related to: static pile load test procedure pdf free- FlexLogger
Sensor configuration and
mixed signal data logging.
- Aerospace and Defense
ATE systems and software for
test program set development.
- Digital Transformation
Strategies to successfully execute
digital transformation.
- Hardware-in-the-Loop Test
Use HIL to test embedded systems
earlier in the design cycle.
- C Series Input Modules
View strain/bridge
input module options.
- SystemLink™
Test data management
and analysis.
- FlexLogger
Search results
Results From The WOW.Com Content Network
Static load testing is an in situ type of load testing used in geotechnical investigation to determine the bearing capacity of deep foundations prior to the construction of a building. It differs from the statnamic load test and dynamic load testing in that the pressure applied to the pile is slower.
Pile integrity testing using low-strain tests such as the TDR (Transient Dynamic Response) method, is a rapid way of assessing the continuity and integrity of concrete piled foundations. The test measures: pile length, or depth to anomalies; pile head stiffness; pile shaft mobility, which is dependent on pile section and concrete properties
Dynamic load testing takes a further step in analyzing the data and computing static capacity and resistance distribution. Dynamic pile monitoring takes advantage of the fact that, for driven piles, it is possible to compute the energy delivered to the pile, compression stresses at the pile top and toe and tension stresses along the shaft.
The Statnamic load test is a type of test for assessing the load-carrying capacity of deep foundations which is faster and less expensive than the static load test.The Statnamic test was conceived in 1985, with the first prototype tests carried out in 1988 through collaboration between Berminghammer Foundation Equipment of Canada and TNO Building Research of the Netherlands.
Iron kentledge weights upon a platform used in static load testing in Haikou, Hainan, China. Kentledge or kentledge weights, are slabs or blocks of concrete or iron (usually pig iron, sometimes with a cast-in handle to assist moving). They are used within ships or boats as permanent, high-density ballast.
Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber piles, dynamic load testing can be done during installation or after installation. The procedure is standardized by ASTM D4945-00 Standard Test Method for High Strain Dynamic Testing of Piles.
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
The test method consists of pushing an instrumented cone, with the tip facing down, into the ground at a controlled rate (controlled between 1.5 -2.5 cm/s accepted). The resolution of the CPT in delineating stratigraphic layers is related to the size of the cone tip, with typical cone tips having a cross-sectional area of either 10 or 15 cm 2 ...
Ad
related to: static pile load test procedure pdf free