When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. What Is Oxygen Bleach? How to Use This Versatile Cleaner - AOL

   www.aol.com/oxygen-bleach-versatile-cleaner...

   Oxygen bleach can safely be used in laundry and on many hard and soft household surfaces, including upholstered furniture, carpets, rugs, and grout.

3. Resuscitator - Wikipedia

   en.wikipedia.org/wiki/Resuscitator

   A resuscitator is a device using positive pressure to inflate the lungs of an unconscious person who is not breathing, in order to keep them oxygenated and alive. [citation needed] There are three basic types: a manual version (also known as a bag valve mask) consisting of a mask and a large hand-squeezed plastic bulb using ambient air, or with supplemental oxygen from a high-pressure tank.

4. What Is a Normal Oxygen Level and How Can I Check Mine? - AOL

   www.aol.com/normal-oxygen-level-check-mine...

   Consumers should use the devices while under a physician’s care and follow up if blood oxygen readings seem to dip precipitously, especially when paired with symptoms like shortness of breath ...

5. Oxygen mask - Wikipedia

   en.wikipedia.org/wiki/Oxygen_mask

   Oxygen supply to divers in decompression chambers is preferably through a built-in breathing system, which uses an oxygen mask plumbed into supply and exhaust hoses which supply oxygen from outside the chamber, and discharge the exhaled oxygen-rich gas outside the chamber, using a system equivalent to two demand valves, one upstream of the ...

6. MAPP gas - Wikipedia

   en.wikipedia.org/wiki/MAPP_gas

   MAPP/oxygen was advantageously used in underwater cutting, which requires high gas pressures (under such pressures acetylene can decompose explosively, making it dangerous to use [5]). However, underwater oxy/fuel gas cutting of any kind has been largely replaced by exothermic cutting [ 6 ] because it cuts more quickly and safely.

7. Oxy-fuel welding and cutting - Wikipedia

   en.wikipedia.org/wiki/Oxy-fuel_welding_and_cutting

   The oxygen flow rate is critical; too little will make a slow ragged cut, while too much will waste oxygen and produce a wide concave cut. Oxygen lances and other custom made torches do not have a separate pressure control for the cutting oxygen, so the cutting oxygen pressure must be controlled using the oxygen regulator.