Search results
Results From The WOW.Com Content Network
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
h ox = 1/h oe, the output impedance of transistor. The parameter h oe usually corresponds to the output admittance of the bipolar transistor and has to be inverted to convert it to an impedance. As shown, the h-parameters have lower-case subscripts and hence signify AC conditions or analyses. For DC conditions they are specified in upper-case.
In electronics, cut-off is a state of negligible conduction that is a property of several types of electronic components when a control parameter (that usually is a well-defined voltage or electric current, but could also be an incident light intensity or a magnetic field), is lowered or increased past a value (the conduction threshold).
An insulated-gate bipolar transistor (IGBT) is a three-terminal power semiconductor device primarily forming an electronic switch. It was developed to combine high efficiency with fast switching. It was developed to combine high efficiency with fast switching.
An organic field-effect transistor (OFET) is a field-effect transistor using an organic semiconductor in its channel. OFETs can be prepared either by vacuum evaporation of small molecules, by solution-casting of polymers or small molecules, or by mechanical transfer of a peeled single-crystalline organic layer onto a substrate.
This current dependency is not supported by the characteristics shown in the diagram above a certain applied voltage. This is the saturation region, and the JFET is normally operated in this constant-current region where device current is virtually unaffected by drain-source voltage. The JFET shares this constant-current characteristic with ...
A ChemFET is a chemically-sensitive field-effect transistor, that is a field-effect transistor used as a sensor for measuring chemical concentrations in solution. [1] When the target analyte concentration changes, the current through the transistor will change accordingly. [2] Here, the analyte solution separates the source and gate electrodes. [3]
These characteristics are also known as I–V curves, referring to the standard symbols for current and voltage. In electronic components with more than two terminals, such as vacuum tubes and transistors , the current–voltage relationship at one pair of terminals may depend on the current or voltage on a third terminal.