Ads
related to: 1970 chevy 396 big block crate engine
Search results
Results From The WOW.Com Content Network
The engine was available through mid-1965, when it was replaced by the 396 cu in (6.5 L) 375 hp (280 kW) Mark IV big-block engine. In addition, a 340 hp (254 kW) version of the 409 engine was available from 1963 to 1965, with a single 4-barrel cast iron intake mounting a Rochester 4GC square-bore carburetor, and hydraulic lifters .
In 1966 the L78 was available exclusively in the intermediate line. For 1967 the engine was additionally available in Chevrolet's new pony car, the Camaro. The following year the motor became available in the compact Chevy II also. For the 1970 model year the 396 was bored 0.03 in (0.76 mm), resulting in a 402 cu in (6.6 L) engine.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
The 1970 Camaro SS 396 had the big block 396 cu in (6.5 L) L78 rated at 350 hp (261 kW). Starting in 1970, the nominal "396" actually displaced 402 cu in (6.6 L), yet Chevrolet chose to retain the 396 badging , equipped with a single 4-barrel Holley carburetor that produced 375 bhp (380 PS; 280 kW) at 5,600 rpm and 415 lb⋅ft (563 N⋅m) at ...
Chevrolet's second generation big-block, the Mark IV had been introduced in 1965 in two 396 cu in (6.5 L) versions. In 1966 Chevrolet added a 427 cu in (7.0 L) version that was available exclusively in the sports car (Corvette) and full-sized (Impala, Bel Air, Biscayne) lines. While a 396 was still available in full-sized cars, the L72 and the ...
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.