Ads
related to: stainless hollow bar sizes table and leaf
Search results
Results From The WOW.Com Content Network
The same is true of metal bar stock. The most common shapes are round bar (also called rod), rectangular bar (including square bar, the special case of equal sides), and hexagonal bar (usually called hex bar for short). Tube and pipe are similar, but have hollow centers and are traditionally not called "bar" in industrial usage. (However, a ...
The bars are generally made of stainless steel or aluminum and touch the chart at each end, while the center is slightly raised to a desired height in order to obtain the desired film thickness. [3] As with the charts, the bars have to be especially resistant to corrosion because of the corrosive nature of some coatings. [ 4 ]
A hollow structural section (HSS) is a type of metal profile with a hollow cross section. The term is used predominantly in the United States, or other countries which follow US construction or engineering terminology. HSS members can be circular, square, or rectangular sections, although other shapes such as elliptical are also available.
The cross-sectional area of a bar, as given by πr², works out to (bar size/9.027)², which is approximated as (bar size/9)² square inches. For example, the area of #8 bar is (8/9)² = 0.79 square inches. Bar sizes larger than #8 follow the 1 ⁄ 8-inch rule
EN10219-1 specifies the technical delivery conditions for cold formed welded structural hollow sections of circular, square or rectangular forms and applies to structural hollow sections formed cold without subsequent heat treatment. Requirements for S275JOH pipe tolerances, dimensions and sectional s275 pipe properties are contained in EN 10219-2.
Thicknesses can vary significantly; extremely thin sheets are considered foil or leaf, and pieces thicker than 6 mm (0.25 in) are considered plate, such as plate steel, a class of structural steel. Sheet metal is available in flat pieces or coiled strips. The coils are formed by running a continuous sheet of metal through a roll slitter.