Ads
related to: stucco that looks like siding trim edge protector
Search results
Results From The WOW.Com Content Network
Stucco or render is a construction material made of aggregates, a binder, and water. Stucco is applied wet and hardens to a very dense solid. It is used as a decorative coating for walls and ceilings, exterior walls, and as a sculptural and artistic material in architecture.
Plywood sheet siding is sometimes used on inexpensive buildings, sometimes with grooves to imitate vertical shiplap siding. One example of such grooved plywood siding is the type called Texture 1–11, T1-11, or T111 ("tee-one-eleven"). There is also a product known as reverse board-and-batten RBB that looks similar but has deeper grooves. Some ...
Marmorino stucco. Marmorino Veneziano is a type of plaster or stucco.It is based on calcium oxide and used for interior and exterior wall decorations. Marmorino plaster can be finished via multiple techniques for a variety of matte, satin, and glossy final effects.
Formstone is a type of stucco [1] commonly applied to brick rowhouses in many East Coast urban areas in the United States, although it is most strongly associated with Baltimore. As a form of simulated masonry , Formstone is commonly colored and shaped on the building to imitate various forms of masonry compound, creating the trompe-l'œil ...
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Pebbledash Pebbledashing Rock dash stucco. Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.
To protect the interior and exterior adobe walls, finishes such as mud plaster, whitewash or stucco can be applied. These protect the adobe wall from water damage, but need to be reapplied periodically. Alternatively, the walls can be finished with other nontraditional plasters that provide longer protection.
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.