Search results
Results From The WOW.Com Content Network
Fault (geology) Satellite image of a fault in the Taklamakan Desert. The two colorful ridges (at bottom left and top right) used to form a single continuous line, but have been split apart by movement along the fault. In geology, a fault is a planar fracture or discontinuity in a volume of rock across which there has been significant ...
Dip is defined as the angle of the fault relative to the surface of the earth, which indicates the plane on which slip will occur. Lastly, in any non-vertical fault, the block above the fault is called the hanging wall, while the blockbelow the fault is called the footwall. [4] Normal and reverse dip-slip faults with labeled hanging wall and ...
A thrust fault is a type of reverse fault, in which the rock above the fault is displaced upwards relative to the rock below the fault. This distinguishes reverse faults from normal faults, where the rock above the fault is displaced downwards, or strike-slip faults, where the rock on one side of the fault is displaced horizontally with respect ...
In geology, horst and graben (or range and valley) refers to topography consisting of alternating raised and lowered fault blocks known as horsts and grabens. The features are created by normal faulting and rifting caused by crustal extension. [1] Horst and graben are formed when normal faults of opposite dip occur in pairs with parallel strike ...
With crustal extension, a series of normal faults which occur in groups, form in close proximity and dipping in opposite directions. [4] As the crust extends it fractures in series of fault planes, some blocks sink down due to gravity, creating long linear valleys or basins also known as grabens, while the blocks remaining up or uplifted produce mountains or ranges, also known as horsts.
A thrust fault is a type of reverse fault that has a dip of 45 degrees or less. [1][2] If the angle of the fault plane is lower (often less than 15 degrees from the horizontal [3]) and the displacement of the overlying block is large (often in the kilometer range) the fault is called an overthrust or overthrust fault. [4]
In geology, transpression is a type of strike-slip deformation that deviates from simple shear because of a simultaneous component of shortening perpendicular to the fault plane. This movement ends up resulting in oblique shear. It is generally very unlikely that a deforming body will experience "pure" shortening or "pure" strike-slip.
Strike-slip faults are associated with dominantly horizontal movement, leading to relatively simple linear zones of surface rupture where the fault is a simple planar structure. However, many strike-slip faults are formed of overlapping segments, leading to complex zones of normal or reverse faulting depending on the nature of the overlap.