Search results
Results From The WOW.Com Content Network
One example of virtual miniport driver usage is to add virtual NICs, each with a different VLAN. Because implementations cannot assume that other drivers received the same buffers, one must treat the incoming buffers as read-only and a driver that changes the packet content must allocate its own buffers.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
The technique specified by the standard is known informally as stacked VLANs or QinQ. The original 802.1Q specification allows a single virtual local area network (VLAN) header to be inserted into an Ethernet frame. QinQ allows multiple VLAN tags to be inserted into a single frame, an essential capability for implementing metro Ethernet.
Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2; Change the native VLAN on all trunk ports to an unused VLAN ID. Switch (config-if)# switchport trunk native vlan 999; Explicit tagging of the native VLAN on all trunk ports.
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.
One analogy is that by creating multiple VLANs, the number of broadcast domains increases, but the size of each broadcast domain decreases. This is because a VLAN defines a broadcast domain. This is achieved by designating one or more provider nodes, either by MAC address or switch port. Broadcast frames are allowed to originate from these ...
LLTD is available for download for 32-bit editions of Windows XP with Service Pack 2 (as a publicly released update) [3] and for Windows XP with Service Pack 3 (as a hotfix by request). [4] LLTD Responder was not released for Windows XP Professional x64 Edition. A 2006 fall update for the Xbox 360 enabled support for the LLTD protocol. [5]