Search results
Results From The WOW.Com Content Network
The engine management system was first utilized on the Saab B204 and B234 "H" engines to monitor and control the fuel injection system and turbocharging pressure control. The Trionic 5.2 and 5.5 systems utilized the manifold absolute pressure (MAP) sensor and the intake air charge temperature sensor to calculate the fuel injection curves, while ...
Significantly Reduce Gen-set Sizing – for variable speed controllers, NFPA-20 2010 paragraph 9.4.3 allows the voltage drop to be no lower than 15% while starting, or lower while starting in bypass (depending on the manufacturers capabilities). Given this, a typical application for a 150 hp motor utilizing soft starting, a gen-set manufacturer ...
An electronically controlled unit injector (EUI) sometimes referred to as a mechanical electronic unit injector (MEUI) is a unit injector (UI) with electronic control. It performs the same function as a conventional unit injector in an internal combustion engine , such as in an on-road or off-road vehicle or a diesel-electric locomotive .
A DC injection brake system can be used as an alternative or addition to a friction brake system. DC injection brakes only require a small module located with the other motor switchgear and/or drivers, mounted in a remote and convenient location, whereas a friction brake must be mounted somewhere on the rotating system.
An everyday example is the cruise control on a road vehicle; where external influences such as gradients cause speed changes (PV), and the driver also alters the desired set speed (SP). The automatic control algorithm restores the actual speed to the desired speed in the optimum way, without delay or overshoot, by altering the power output of ...
The key feature of the Ward Leonard control system is the ability to smoothly vary the speed of a DC motor, including reversing it, by controlling the field and hence the output voltage of a DC generator, as well as the field of the motor itself. As the speed of a DC motor is dictated by the supplied voltage, this gives simple speed control.
The balls swing out as speed increases, which closes the valve, until a balance is achieved between demand and the proportional gain of the linkage and valve. A centrifugal governor is a specific type of governor with a feedback system that controls the speed of an engine by regulating the flow of fuel or working fluid , so as to maintain a ...
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors.This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.