Search results
Results From The WOW.Com Content Network
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
Pontiac differed from other GM Divisions and most other manufacturers in producing only a single sized V8 casting, rather than adding a larger big block to its line-up. The external dimensions of all their V8s, from 326–455 cu in (5.3–7.5 L) were the same. Engine displacement is a function of bore and stroke.
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
De Dion-Bouton engine with monobloc cylinder heads, but cylinders separate from crankcase c. 1905 [1]. A monobloc or en bloc engine is an internal-combustion piston engine some of whose major components (such as cylinder head, cylinder block, or crankcase) are formed, usually by casting, as a single integral unit, rather than being assembled later.
Permanent mold casting is a metal casting process that employs reusable molds ("permanent molds"), usually made from metal. The most common process uses gravity to fill the mold. However, gas pressure or a vacuum are also used. A variation on the typical gravity casting process, called slush casting, produces hollow castings.
Typical products made using this process are television tubes and missile nose cones. [citation needed] Spin casting is also used to manufacture large telescope mirrors, where the natural curve followed by the molten glass greatly reduces the amount of grinding required. Rather than pouring glass into a mold an entire turntable containing the ...
Additionally, the range of axial orientations in the directional solidification starting block should be minimized in order to successfully grow a single crystal. [12] This is difficult depending on the range of orientations in the DS starter block, and therefore makes orientation control a large area of focus.
A bronze casting showing the sprue and risers. A riser, also known as a feeder, [1] is a reservoir built into a metal casting mold to prevent cavities due to shrinkage.Most metals are less dense as a liquid than as a solid so castings shrink upon cooling, which can leave a void at the last point to solidify.