Ads
related to: patch mortar between bricks outside ground coverage
Search results
Results From The WOW.Com Content Network
A DPC is a durable, impermeable material such as slate, felt paper, metal, plastic or special engineered bricks [7] bedded into the mortar between two courses of bricks or blocks. It can often be seen as a thin line in the mortar near ground level. To create a continuous barrier, pieces of DPC or DPM may be sealed together.
So for example, if a soft lime-based mortar was originally used, the most appropriate repointing mortar is likely to also contain a large amount of lime. [4] Restoration (before and after) of a Georgian brick facade in Limerick, re-pointed in Irish Wigging, using hybrid lime mix mortar, after replacing damaged bricks with matching salvaged bricks
Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]
Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.
This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint. Because the mortar is not compressed, it is less water-resistant than some of the other designs. Tuckpointing This joint has mortar colored to match the bricks surrounding a line of white mortar to make the joints look very small.
Injection of a liquid or cream into bricks or mortar is the most common method of treating rising damp. Adolf Wilhelm Keim describes the use of a hot bitumen remedial damp-proof course that is injected into holes drilled into a wall in his 1902 publication "The Prevention of Dampness in Buildings."
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Brick trowel: or mason's trowel is a point-nosed trowel for spreading mortar on bricks or concrete blocks with a technique called "buttering". The shape of the blade allows for very precise control of mortar placement. Bucket trowel: a wide-bladed tool for scooping mortar from a bucket; it is also good for buttering bricks and smoothing mortar.