Ad
related to: akai vacuum tube receiver parts breakdown diagram
Search results
Results From The WOW.Com Content Network
In the 1950s a 5-element system (Russian: Государственный Стандарт "State standard" ГОСТ/GOST 5461–59, later 13393–76) was adopted in the (then) Soviet Union for designating receiver vacuum tubes. [27] [28] The first element is a number specifying filament voltage.
English: Block diagram of a tuned radio frequency (TRF) receiver, a type of radio receiver circuit invented in 1916 by Ernst Alexanderson and widely used in the vacuum tube receivers of the 1920s.
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
The term All American Five (abbreviated AA5) is a colloquial name for mass-produced, superheterodyne radio receivers that used five vacuum tubes in their design. These radio sets were designed to receive amplitude modulation (AM) broadcasts in the medium wave band, and were manufactured in the United States from the mid-1930s until the early 1960s.
An AC/DC receiver design is a style of power supply of vacuum tube radio or television receivers that eliminated the bulky and expensive mains transformer. A side-effect of the design was that the receiver could in principle operate from a DC supply as well as an AC supply. Consequently, they were known as "AC/DC receivers".
Later thermionic vacuum tubes, mostly miniature style, some with top cap connections for higher voltages. A vacuum tube, electron tube, [1] [2] [3] [thermionic] valve (British usage), or tube (North America) [4] is a device that controls electric current flow in a high vacuum between electrodes to which an electric potential difference has been applied.
Glowing cathodes in two transmitting vacuum tubes. Repair and restoration of vintage amateur radio equipment may involve replacing vacuum tubes, reforming electrolytic capacitors if needed, replacing any faulty resistors, replacing two-wire power cords with three-wire cords except on transformerless AC/DC radios, and receiver alignment as ...
Parts of a small receiving-type beam tetrode Pictures The glass envelope has been removed. View of the tube base, anode or plate and getter pan. The anode is the large, gray colored, cylindrical structure. The getter pan is the cup-shaped part at the top. The getter is a powdered metal that reacts strongly to oxygen.