Search results
Results From The WOW.Com Content Network
A deep-cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or cranking automotive batteries designed to deliver only a small part of their capacity in a short ...
Example charging graph. On the left: per-cell quantities. On the right: example values for a 40 Ah, 6-cell (12 V) battery. Note: schematic illustration; not based on actual measurements. IUoU is a DIN-designation [1] (DIN 41773) for a lead-acid battery charging procedure that is also known as 3-stage charging, 3-phase charging, or 3-step charging.
The first generation rechargeable alkaline batteries were introduced by Union Carbide and Mallory in the early 1970s. [3] [5] Several patents were introduced after Union Carbide's product discontinuation and eventually, in 1986, Battery Technologies Inc of Canada was founded to commercially develop a 2nd generation product based on those patents, under the trademark "RAM".
Deep-cycle batteries are also used as auxiliary batteries in recreational vehicles, but they require different, multi-stage charging. Discharging below 50% can shorten the battery's life. [36] Flooded batteries require inspection of electrolyte levels and occasional replacement of water, which gases away during the normal charging cycle.
the fraction of the battery's capacity which is currently removed from the battery with regard to its (fully) charged state. For fully charged batteries, the depth of discharge is connected to the state of charge by the simple formula =. The depth of discharge then is the complement of state of charge: as one increases, the other decreases.
Charging a 12 V lead–acid car battery A mobile phone plugged in to an AC adapter for charging. A battery charger, recharger, or simply charger, [1] [2] is a device that stores energy in an electric battery by running current through it.
The energy used to charge rechargeable batteries usually comes from a battery charger using AC mains electricity, although some are equipped to use a vehicle's 12-volt DC power outlet. The voltage of the source must be higher than that of the battery to force current to flow into it, but not too much higher or the battery may be damaged.
A typical 12 V, 40 Ah lead-acid car battery. An automotive battery, or car battery, is a rechargeable battery that is used to start a motor vehicle.. Its main purpose is to provide an electric current to the electric-powered starting motor, which in turn starts the chemically-powered internal combustion engine that actually propels the vehicle.