Search results
Results From The WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
An example of router on a stick usage is found in Call Manager Express installation, when the Voice over IP network and Cisco IP phone devices have a need to split. [3] Enterprise networks implement this method of separating servers to prevent all users from ‘having equal access privilege to resources’.
One or more logical or physical interfaces may have a VRF and these VRFs do not share routes. Therefore, the packets are only forwarded between interfaces on the same VRF. VRFs are the TCP/IP layer 3 equivalent of a VLAN. Because the routing instances are independent, the same or overlapping IP addresses can be used without conflicting with ...
Cisco Unity Connection - Voice messaging system for CUCM. [21] Cisco Paging Server (InformaCast) - Paging/bell/mass notification system for CUCM. Originally developed by Singlewire Software, sold as a Cisco product. [22] Cisco Unified Communications Manager Express (CUCME) - a small scale/single server contact center solution
The IEEE now considers the label MAC-48 to be an obsolete term which was previously used to refer to a specific type of EUI-48 identifier used to address hardware interfaces (e.g., Network Interface Controllers and other network hardware) within existing IEEE 802 based networking applications and should not be used in the future. [5]
InterSwitch Trunk (IST) is one or more parallel point-to-point links (Link aggregation) that connect two switches together to create a single logical switch.The IST allows the two switches to share addressing information, forwarding tables, and state information, permitting rapid (less than one second) fault detection and forwarding path modification.
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet. It is a dynamic table that maps MAC addresses to ports.
When a multicast packet enters a router's interface, the router looks up the list of networks that are reachable via that interface (i.e., it checks the paths by which the packet could have arrived). If the router finds a matching routing entry for the source IP address of the multicast packet, the RPF check passes and the packet is forwarded ...