When.com Web Search

  1. Ads

    related to: ship propeller shaft coupling

Search results

  1. Results From The WOW.Com Content Network
  2. Combined gas and gas - Wikipedia

    en.wikipedia.org/wiki/Combined_gas_and_gas

    Combined gas turbine and gas turbine (COGAG) is a type of propulsion system for ships using two gas turbines connected to a single propeller shaft. A gearbox and clutches allow either of the turbines to drive the shaft or both of them combined. Marine usage of COGAG systems are similar to those found ashore.

  3. White's Marine Engineering Company - Wikipedia

    en.wikipedia.org/wiki/White's_Marine_Engineering...

    In 1926 two German engineers, Dr Gustav Bauer and Hans Wach, had increased the efficiency of a triple expansion engine by adding a turbine driven by exhaust steam from the low-pressure cylinder, and adding the power from the turbine to the same propeller shaft via a fluid coupling and double-reduction gearing.

  4. Marine propulsion - Wikipedia

    en.wikipedia.org/wiki/Marine_propulsion

    Ships propelled by medium or high speed diesel engines may have one or two (sometimes more) propellers, commonly with one or more engines driving each propeller shaft through a gearbox. Where more than one engine is geared to a single shaft, each engine will most likely drive through a clutch, allowing engines not being used to be disconnected ...

  5. Azipod - Wikipedia

    en.wikipedia.org/wiki/Azipod

    In the conventional azimuth thrusters such as Z-drive and L-drive thrusters, the propeller is driven by an electric motor or a diesel engine inside the ship's hull. The propeller is coupled to the prime mover with shafts and bevel gears that allow rotating the propeller about a vertical axis. This type of propulsion system has a long tradition ...

  6. Azimuth thruster - Wikipedia

    en.wikipedia.org/wiki/Azimuth_thruster

    Mechanical transmission, which connects a motor inside the ship to the outboard unit by gearing. The motor may be diesel or diesel-electric. Depending on the shaft arrangement, mechanical azimuth thrusters are divided into L-drive and Z-drive. An L-drive thruster has a vertical input shaft and a horizontal output shaft with one right-angle gear.

  7. SS Great Britain - Wikipedia

    en.wikipedia.org/wiki/SS_Great_Britain

    At each end of the main propeller shaft were two secondary coupling shafts: a 28-foot (8.5 m), 16-inch (41 cm) diameter shaft beneath the engine, and a screw shaft of 25 ft (7.6 m) in length and with a diameter of 16 inches (41 cm) at the stern. Total length of the three shafts was 130 ft (40 m), and the total weight 38 tons. [25]