Search results
Results From The WOW.Com Content Network
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot .
Hibernation (also known as suspend to disk, or Safe Sleep on Macintosh computers [1]) in computing is powering down a computer while retaining its state.When hibernation begins, the computer saves the contents of its random access memory (RAM) to a hard disk or other non-volatile storage.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
Linux, macOS, Windows Fedora: GNOME Disks: Gnome disks contributors GPL-2.0-or-later: Yes No Linux Anything LinuxLive USB Creator (LiLi) Thibaut Lauzière GNU GPL v3: No No Windows Linux remastersys: Tony Brijeski GNU GPL v2: No [2] No Debian, Linux Mint, Ubuntu Debian and derivatives Rufus: Pete Batard GNU GPL v3: Yes No Windows Anything ...
A physical Wake-on-LAN connector (white object in foreground) featured on the IBM PCI Token-Ring Adapter 2. Wake-on-LAN (WoL or WOL) [a] is an Ethernet or Token Ring computer networking standard that allows a computer to be turned on or awakened from sleep mode by a network message.
The actual suspend is done by: echo shutdown > /sys/power/disk; echo disk > /sys/power/state. You may check other suspend options available by doing cat /sys/power/state. depending on your kernel config, it will show something similar to [standby] mem disk. and options available under disk can be viewed by cat /sys/power/disk
Non-Macintosh systems, notably Windows and Linux, may not be typically booted in EFI mode and thus USB booting may be limited to supported hardware and software combinations that can easily be booted via EFI. [8] However, programs like Mac Linux USB Loader can alleviate the difficulties of the task of booting a Linux-live USB on a Mac.
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams