Search results
Results From The WOW.Com Content Network
DirectLOGIC is a range of programmable logic controllers produced by Koyo. They are programmed using DirectSOFT via: RS-232; USB port with USB-to-Serial adapter; 10BASE-T or 10/100 Ethernet network card
Koyo Electronics (Kōyō Denki) and its subsidiary Koyo Electronics Industry (Kōyō Denshi Kōgyō), often collectively referred to as just Koyo, are Japanese electronics companies based in Kodaira, Tokyo [2] that manufactured radios from 1955 until 1973, and now its subsidiary manufactures industrial electronics devices and factory automation control systems.
DF-1 - used by Allen-Bradley ControlLogix, CompactLogix, PLC-5, SLC-500, and MicroLogix class devices; DNP3 - a protocol used to communicate by industrial control and utility SCADA systems; DirectNet – Koyo / Automation Direct proprietary, yet documented PLC interface; EtherCAT; Ethernet Global Data (EGD) – GE Fanuc PLCs (see also SRTP)
A programmable logic controller (PLC) or programmable controller is an industrial computer that has been ruggedized and adapted for the control of manufacturing processes, such as assembly lines, machines, robotic devices, or any activity that requires high reliability, ease of programming, and process fault diagnosis.
Koyo DirectNET protocol is used by DirectLOGIC PLCs from Automation Direct and is used in APS vacuum controls since 1999. It is a master/slave protocol making use of RS-232 or RS-422 physical layers with a baud rate from 300 to 38,400. It is designed to drive a maximum of 90 PLCs on a serial line.
A feedback control loop is directly controlled by the RTU or PLC, but the SCADA software monitors the overall performance of the loop. For example, a PLC may control the flow of cooling water through part of an industrial process to a set point level, but the SCADA system software will allow operators to change the set points for the flow.
In 1986, GE Fanuc Automation Corporation was jointly established in the US by FANUC and General Electric (GE). Under the joint venture company, three operating companies, GE Fanuc Automation North America, Inc., in the U.S., GE Fanuc Automation Europe S.A. in Luxembourg, and Fanuc GE Automation Asia Ltd. in Japan were established (the Asian company was established in 1987).
Automation engineers are responsible for creating detailed design specifications and other documents, developing automation based on specific requirements for the process involved, and conforming to international standards like IEC-61508, local standards, and other process specific guidelines and specifications, simulate, test and commission ...