Ads
related to: where to mount trx anchor cable for boats
Search results
Results From The WOW.Com Content Network
This type consists of a rod with wide screw blades on the end and an eyelet on the other for the guy wire. It is screwed deep into the ground, at the same angle as the guy, by a truck-mounted drill machine. These are commonly used as guy anchors for utility poles since they are quick to install with a truck mounted hydraulic powered auger drive.
Aweigh: just clear of the sea floor, as with an anchor. [12] Below: a lower deck of the ship. [1] Belowdecks: inside or into a ship, or down to a lower deck. [13] Bilge: the underwater part of a ship between the flat of the bottom and the vertical topsides [14] Bottom: the lowest part of the ship's hull. Bow: front of a ship (opposite of "stern ...
One of the primary characteristics of this technique is the use of a swivel as follows: the first anchor is set normally, and the vessel drops back to the limit of anchor cable. A second anchor is attached to the end of the anchor cable, and is dropped and set. A swivel is attached to the middle of the anchor cable, and the vessel connected to ...
Also, a wet cable or chain would be difficult to manage. A messenger would then be used as an intermediate device. This was a continuous loop of cable or chain which would go around the capstan. The main anchor cable or chain would then be attached to the messenger for hauling using some temporary connection such as ropes called nippers.
A nautical cable is a band of tightly woven and clamped ropes, of a defined cable length, used during the age of sail for deep water anchoring, heavy lifting, ship to ship transfers and towing during blue sea sailing and other uses.
The line allows the anchor to be unhooked from an obstruction, such as a rock or another vessel's anchor cable, so preventing raising the anchor in the normal way. [14] anchor chain . Also anchor cable. A chain connecting a ship to an anchor. anchor detail A group of men who handle ground tackle when the ship is anchoring or getting under way ...
Bitts aboard wooden sailing ships (sometime called cable-bitts) were large vertical timbers mortised into the keel and used as the anchor cable attachment point. [2] Bitts are carefully manufactured and maintained to avoid any sharp edges that might chafe and weaken the mooring lines.
A guyed radio mast. A guyed mast is a tall thin vertical structure that depends on guy lines (diagonal tensioned cables attached to the ground or a base) for stability. The mast itself has the compressive strength to support its own weight, but does not have the shear strength to stand unsupported or bear loads.