When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Load cell - Wikipedia

    en.wikipedia.org/wiki/Load_cell

    A load cell converts a force such as tension, compression, pressure, or torque into a signal (electrical, pneumatic or hydraulic pressure, or mechanical displacement indicator) that can be measured and standardized. It is a force transducer. As the force applied to the load cell increases, the signal changes proportionally.

  3. Qi (standard) - Wikipedia

    en.wikipedia.org/wiki/Qi_(standard)

    Qi (/ tʃ iː / CHEE) is an open standard for inductive charging developed by the Wireless Power Consortium.It allows compatible devices, such as smartphones, to receive power when placed on a Qi charger, which can be effective over distances up to 4 cm (1.6 in). [1]

  4. Does Charging Your Phone To 100% Ruin Your Battery? Here's ...

    www.aol.com/does-charging-phone-100-ruin...

    Keeping your phone plugged in once it hits a full charge and consistently charging it to 100% keeps the battery at a high voltage, which causes chemical aging in the product, said Dibakar Datta ...

  5. Power electronics - Wikipedia

    en.wikipedia.org/wiki/Power_electronics

    The full-bridge inverter is similar to the half bridge-inverter, but it has an additional leg to connect the neutral point to the load. [17] Figure 3 shows the circuit schematic of the single-phase voltage source full-bridge inverter.

  6. Diode bridge - Wikipedia

    en.wikipedia.org/wiki/Diode_bridge

    This is an accepted version of this page This is the latest accepted revision, reviewed on 8 October 2024. Circuit arrangement of four diodes Diode bridge Diode bridge in various packages Type Semiconductor Inventor Karol Pollak in 1895 Electronic symbol 2 alternating-current (AC) inputs converted into 2 direct-current (DC) outputs A hand-made diode bridge. The silver band on the diodes ...

  7. Duplex (telecommunications) - Wikipedia

    en.wikipedia.org/wiki/Duplex_(telecommunications)

    For example, a walkie-talkie or a DECT phone or so-called TDD 4G or 5G phones requires only a single frequency for bidirectional communication, while a cell phone in the so-called FDD mode is a full-duplex device, and generally requires two frequencies to carry the two simultaneous voice channels, one in each direction.

  8. Battery charger - Wikipedia

    en.wikipedia.org/wiki/Battery_charger

    A properly designed charger can allow batteries to reach their full cycle life. Excess charging current, lengthy overcharging, or cell reversal in a multiple cell pack cause damage to cells and limit the life expectancy of a battery. Most modern cell phones, laptop and tablet computers, and most electric vehicles use lithium-ion batteries. [28]

  9. Comparison of mobile phone standards - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_mobile_phone...

    Unlimited cell size, low transmitter power permits large cells Very low density Soft No 3G: CDMA: IS-2000 (CDMA 2000) Digital: 2000 / 2002 Limited RUIM (rarely used) None Unlimited cell size, low transmitter power permits large cells Very low density Soft No EVDO / Yes SVDO [2] 3G: W-CDMA: UMTS (3GSM) Digital: 2001 Worldwide SIM card: None