Ads
related to: 1 2 through hull fitting diagram for boats parts manual instructions free
Search results
Results From The WOW.Com Content Network
Clinker-built, also known as lapstrake-built, [1] [2] is a method of boat building in which the edges of longitudinal (lengthwise-running) hull planks overlap each other. Where necessary in larger craft, shorter hull planks can be joined end to end, creating a longer hull plank ().
A small boat stuffing box comprising an adjusting nut, a locking nut and a sleeve. On a boat having an inboard motor that turns a shaft attached to an external propeller, the shaft passes through a stuffing box, also called a "packing box" or "stern gland" in this application. The stuffing box prevents water from entering the boat's hull.
Then, on a single day, the cement is applied by a team of plasterers. The cement:sand ratio is a very rich 4:1. As the hull thickness is typically 2.5 to 3 cms, ferrocement is unsuitable for boats less than about 15 metres LOA as there is a weight penalty; above that length there is no penalty. Properly plastered ferrocement boats have smooth ...
Carvel built or carvel planking is a method of boat building in which hull planks are laid edge to edge and fastened to a robust frame, thereby forming a smooth surface. Traditionally the planks are neither attached to, nor slotted into, each other, having only a caulking sealant between the planks to keep water out.
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy ), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures , such as a funnel, derrick, or mast .
Garboard strakes and related near-keel members Diagram of typical modern metal-hulled ship’s exterior plating, with a single strake highlighted in red. On a vessel's hull, a strake is a longitudinal course of planking or plating which runs from the boat's stempost (at the bows) to the sternpost or transom (at the rear).