Search results
Results From The WOW.Com Content Network
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.
It is performed by reading the binary number from left to right, doubling if the next bit is zero, and doubling and adding one if the next bit is one. [5] In the example above, 11110011, the thought process would be: "one, three, seven, fifteen, thirty, sixty, one hundred twenty-one, two hundred forty-three", the same result as that obtained above.
An XNOR gate is a basic comparator, because its output is "1" only if its two input bits are equal. The analog equivalent of digital comparator is the voltage comparator . Many microcontrollers have analog comparators on some of their inputs that can be read or trigger an interrupt .
A simple sorting network consisting of four wires and five connectors. In computer science, comparator networks are abstract devices built up of a fixed number of "wires", carrying values, and comparator modules that connect pairs of wires, swapping the values on the wires if they are not in a desired order.
4-bit adder with logical block diagram shown Decimal 4-digit ripple carry adder. FA = full adder, HA = half adder. It is possible to create a logical circuit using multiple full adders to add N-bit numbers. Each full adder inputs a , which is the of the previous adder.
The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...
In most cases a comparator is implemented using a dedicated comparator IC, but op-amps may be used as an alternative. Comparator diagrams and op-amp diagrams use the same symbols. A simple comparator circuit made using an op-amp without feedback simply heavily amplifies the voltage difference between Vin and VREF and outputs the result as Vout.
A single comparator gate. A comparator circuit is a network of wires and gates. Each comparator gate, which is a directed edge connecting two wires, takes its two inputs and outputs them in sorted order (the larger value ending up in the wire the edge is pointing to). The input to any wire can be either a variable, its negation, or a constant.