Ad
related to: pump runs but no water
Search results
Results From The WOW.Com Content Network
Crestview Mutual Water Co. reported to its water wholesaler that the pump was out from 2 p.m. until 11 p.m., when a generator was finally hooked up. It's still not clear what effect those issues ...
The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw, it can run horizontally while the Archimedean screw is tilted at about 30°. The coil pump, if fitted with a suitable rotating seal, can deliver water to a greater height, typically 5-10m, above their discharge opening. [2]
At 8:15am, the mayor reported that they had had the most positive step of the last 12 hours [29] which was the fact that two pumps had started actively running and that one of the tanks was actively being filled; [29] additionally, computer systems had been restored. [37] However, water service was still not restored for much of the city. [29]
Condensate pumps usually run intermittently and have a tank in which condensate can accumulate. Eventually, the accumulating liquid raises a float switch energizing the pump. The pump then runs until the level of liquid in the tank is substantially lowered. Some pumps contain a two-stage switch.
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Discharge cavitation occurs when the pump discharge pressure is extremely high, normally occurring in a pump that is running at less than 10% of its best efficiency point. The high discharge pressure causes the majority of the fluid to circulate inside the pump instead of being allowed to flow out the discharge.
A minimum flow protection system ensures that the pump is not operated below the minimum flow rate. The system protects the pump even if it is shut-in or dead-headed, that is, if the discharge line is completely closed. [44] The simplest minimum flow system is a pipe running from the pump discharge line back to the suction line.
This pumps water from the nearby River Avon to the canal using pumps driven by a waterwheel which is powered by the river. [2] Where no external water supply is available, back pumping systems may be employed.