Search results
Results From The WOW.Com Content Network
In an aqueous solution, precipitation is the "sedimentation of a solid material (a precipitate) from a liquid solution". [1] [2] The solid formed is called the precipitate. [3] In case of an inorganic chemical reaction leading to precipitation, the chemical reagent causing the solid to form is called the precipitant. [4]
If the substance lacks the ability to dissolve in water, the molecules form a precipitate. [3] When writing the equations of precipitation reactions, it is essential to determine the precipitate. To determine the precipitate, one must consult a chart of solubility. Soluble compounds are aqueous, while insoluble compounds are the precipitate.
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.
Gravimetric analysis describes a set of methods used in analytical chemistry for the quantitative determination of an analyte (the ion being analyzed) based on its mass. The principle of this type of analysis is that once an ion's mass has been determined as a unique compound, that known measurement can then be used to determine the same analyte's mass in a mixture, as long as the relative ...
In chemistry, coprecipitation (CPT) or co-precipitation is the carrying down by a precipitate of substances normally soluble under the conditions employed. [1] Analogously, in medicine, coprecipitation (referred to as immunoprecipitation) is specifically "an assay designed to purify a single antigen from a complex mixture using a specific antibody attached to a beaded support".
The term precipitation is normally reserved for describing a phase change from a colloid dispersion to a solid (precipitate) when it is subjected to a perturbation. [19] Aggregation causes sedimentation or creaming, therefore the colloid is unstable: if either of these processes occur the colloid will no longer be a suspension.
Salting out is typically used to precipitate large biomolecules, such as proteins or DNA. [2] Because the salt concentration needed for a given protein to precipitate out of the solution differs from protein to protein, a specific salt concentration can be used to precipitate a target protein. This process is also used to concentrate dilute ...
On the leeward side of mountains, desert climates can exist due to the dry air caused by compressional heating. Most precipitation occurs within the tropics and is caused by convection. [3] Precipitation is a major component of the water cycle, and is responsible for depositing most of the fresh water on the planet.