Ads
related to: class 1 load manager p/n 101709 4 10 5 ribbon connectors cross reference
Search results
Results From The WOW.Com Content Network
A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
The de facto standard 8 inch FDD interface is based upon the Shugart Associates models SA800/801 [3] FDDs and models SA850/851 [4] FDDs. [5]: 171 The signal interface uses a 50-pin PCB edge connector which mates to a flat ribbon cable connector. Separate connectors are provided for both AC and DC power, as many 8 inch drives used AC spindle motors.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
However a 10 A 5-pin plug cannot fit a 32 A 5-pin socket, as the plugs are in different groups and not only are their diameters different, but the position of the conductors also varies by a few degrees (for example the group 7/8 32 A plug has its L and N pins at 9 o'clock and 3 o'clock, while the group 1/2 20 A plug has its L and N pins at 10 ...
Cross section of an N connector mated pair. The interface specifications for the N and many other connectors are referenced in MIL-STD-348. [3] Originally, the connector was designed to carry signals at frequencies up to 1 GHz in military applications, but today's common Type N easily handles frequencies up to 11 GHz.
Variety of loose pogo pins and pogo pins in 3-pin assembly holders and with Pick and Place caps Sectional drawing of a pogo pin, showing the plunger, barrel, and spring. A pogo pin or spring-loaded pin is a type of electrical connector mechanism with spring plungers that is used in many modern electronic applications and in the electronics testing industry. [1]
High-pin count (HPC), 400 I/O FPGA Mezzanine Card (FMC) connectors Top: mezzanine card side Bottom: baseboard side. FPGA Mezzanine Card (FMC) is an ANSI/VITA (VMEbus International Trade Association) 57.1 standard that defines I/O mezzanine modules with connection to an FPGA or other device with re-configurable I/O capability.