Search results
Results From The WOW.Com Content Network
The MIL-STD-883 standard establishes uniform methods, controls, and procedures for testing microelectronic devices suitable for use within military and aerospace electronic systems including basic environmental tests to determine resistance to deleterious effects of natural elements and conditions surrounding military and space operations; mechanical and electrical tests; workmanship and ...
According to method 2020.9 of MIL-STD-883 and method 2052.5 of MIL-STD-750, the purpose of a PIND test is to detect loose particles inside an electronics device cavity. The test provides a nondestructive means of identifying those devices containing particles of sufficient mass that, upon impact within the cavity, excite the transducer .
MIL-STD-883 methods 2011.9 destructive bond pull test [1] and 2031.1 flip chip pull off test [2] apply, as well as JEDEC JESD22-B109. Partial coring may be used, if necessary, to eliminate surface skin effects.
"mil-std-781d, military standard, reliability testing for engineering development, qualification, and production (s/s by mil-hdbk-781a)" (pdf). united states department of defense. 17 oct 1986. "mil-std-810g, department of defense test method standard, environmental engineering considerations and laboratory tests" (pdf).
MIL-STD-810, test methods for determining the environmental effects on equipment [24] MIL-STD-882, standard practice for system safety [25] MIL-STD-883, test method standard for microcircuits [26] MIL-STD-1168, a classification system for ammunition production that replaced the Ammunition Identification Code (AIC) system used during World War II.
The HBM definition most widely used is the test model defined in the United States military standard, MIL-STD-883, Method 3015.9, Electrostatic Discharge Sensitivity Classification. This method establishes a simplified equivalent electrical circuit and the necessary test procedures required to model an HBM ESD event.
The purpose of the test is as MIL-STD-883 2011.9 describes it: "To measure bond strengths, evaluate bond strength distributions, or determine compliance with specified bond strength requirements". A wire can be pulled to destruction, but there are also non-destructive variants whereby one tests whether the wire can withstand a certain force.
The dip and look method is a qualitative test. One form of it is specified as Mil-Std-883 Method 2003. On the other hand, the wetting balance analysis is a quantitative test that measures the wetting forces between molten solder and the test surface as a function of time.