Ads
related to: waterproof leds circuit board
Search results
Results From The WOW.Com Content Network
An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .
As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5] Conformal coating gives most of the benefits of potting, and is lighter and easier to inspect, test, and repair. Conformal coatings can be applied as liquid or condensed from a vapor phase.
Incorrect selection can affect long-term reliability of the circuit board as well as cause processing and cost problems. [8] The most common [citation needed] standards for conformal coating are IPC A-610 [9] and IPC-CC-830. [10] These standards list indications of good and bad coverage and describe various failure mechanisms, such as dewetting.
An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .
Also used for LEDs. In LEDs, transparent epoxy or a silicon caulk-like material that may contain a phosphor is poured into a mold containing the LED(s) and cured. The mold forms part of the package. COF: Chip-on-flex: Variation of COB, where a chip is mounted directly to a flex circuit.
Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.