Ads
related to: round bullet mold
Search results
Results From The WOW.Com Content Network
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
A semiwadcutter (SWC) or flat-nose is a type of all-purpose bullet commonly used in revolvers.The SWC combines features of the traditional round-nosed bullets and the wadcutter bullets used in target shooting, and is used in both revolver and rifle cartridges for hunting, target shooting and plinking.
Gas checks are most commonly found in the form of a thin cup or disc made of a ductile metal. Copper, zinc, aluminum, and alloys such as brass have been used. A bullet designed to accept a gas check has a rebated base shank which permits attachment of the check without altering the maximum diameter of the bullet.
A ballistic tip bullet is a hollow-point rifle bullet that has a plastic tip on the end of the bullet. This improves external ballistics by streamlining the bullet, allowing it to cut through the air more easily, and improves terminal ballistics by allowing the bullet to act as a jacketed hollow point.
The .375 Viking bullet had an overall length of 70 mm (2.756 in) and derived its anticipated low drag from a radical LD Haack or Sears-Haack profile in the bullet's nose area. Rifles chambered for this wildcat cartridge, with a cartridge overall length of 119 mm (4.685 in), were to have been equipped with custom made 762 mm (30 in) long 203 mm ...
And, it is the single round smaller than the 375 H&H Magnum that has routinely been allowed for legal hunting of dangerous African species. 12.7×108mm: The 12.7×108mm round is a heavy machine gun and anti-materiel rifle round used by the Soviet Union, the former Warsaw Pact, modern Russia, and other countries. It is the approximate Russian ...
The Minié ball is a cylindro-conoidal bullet with grease-filled cannelures on its exterior and a cone-shaped hollow in its base.Minié designed the bullet with a small iron plug, and lead skirting that would expand under the pressure of gunpowder deflagration causing the bullet to obturate, and grip the rifling grooves.
The first successful documented case of forensic firearm examination occurred in 1835 when a member of the Bow Street Runners in London matched a recovered bullet from a murder victim to a specific mold in a suspect's home confirming that he made the bullet; this gave further evidence that the bullet maker was the perpetrator and he was ...