Ads
related to: gm ring gear identification
Search results
Results From The WOW.Com Content Network
Distinguishing it from the GM 14-bolt 9.5-inch ring gear rear differential is the latter's utilization of C-clips to retain axles, differing from the free-floating axle mechanism of its heavy-duty counterpart.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints. The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door ...
Ring gear diameter: 9 3 ⁄ 4 " Axle shaft diameter 1.41” Front (32 spline) 1.46” Rear (32 spline) 1.50” Front (35 spline) 1.50” Rear (35 spline) Inner axle shaft splines: 16, 23, 30, 32, 33 or 35 Aftermarket inner axle shaft splines: 40 for after market, high performance axles, equivalent to Dana 70 components; Pinion shaft diameter: 1 ...
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
The "S" meaning: single rear axle. The first "1" representing gear reduction type, the second representing the head assembly series and the last "0" representing the design level. The Dana S110 is used in Class 4 and Class 5 applications. Dodge, Ford and General Motors use this axle as well as various other
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
This ring and pinion is significantly stronger with a better pinion to ring gear tooth contact patch and angle. It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers.