Search results
Results From The WOW.Com Content Network
It is produced by polishing the metal with a 120–180 grit belt or wheel finish and then softened with an 80–120 grit greaseless compound or a medium non woven abrasive belt or pad. #4 Dairy or sanitary finish. This finish is commonly used for the medical and food industry and almost exclusively used on stainless steel.
Surface finish, also known as surface texture or surface topography, is the nature of a surface as defined by the three characteristics of lay, surface roughness, and waviness. [1] It comprises the small, local deviations of a surface from the perfectly flat ideal (a true plane ).
Mill finish is the surface texture (or finish) of metal after it exits a rolling mill, extrusion die, or drawing processes, including sheet, bar, plate, or structural shapes. This texture is usually rough and lacks lustre; it may have spots of oxidation or contamination with mill oil.
The standard is based on the ″M″ (mean line) system. There are many different roughness parameters in use, but R a {\displaystyle Ra} is by far the most common, though this is often for historical reasons and not for particular merit, as the early roughness meters could only measure R a {\displaystyle Ra} .
The 16 Divisions of construction, as defined by the Construction Specifications Institute (CSI)'s MasterFormat, is the most widely used standard for organizing specifications and other written information for commercial and institutional building projects in the U.S. and Canada.
Turned, ground, and polished (TGP) is a classification of finishing processes often used for metal shafting. Turning (on a lathe) creates straight round bars without the strain induced by cold drawing, while grinding and polishing improves the surface finish and roundness for high dimensional accuracy. [1]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.