Search results
Results From The WOW.Com Content Network
The DPO is calculated by subtracting the simple moving average over an n day period and shifted (n / 2 + 1) days back from the price. To calculate the detrended price oscillator: [5] Decide on the time frame that you wish to analyze. Set n as half of that cycle period. Calculate a simple moving average for n periods. Calculate (n / 2 + 1).
The standard interpretation of such an event is a recommendation to buy if the MACD line crosses up through the average line (a "bullish" crossover), or to sell if it crosses down through the average line (a "bearish" crossover). [7]
In time series analysis, a fan chart is a chart that joins a simple line chart for observed past data, by showing ranges for possible values of future data together with a line showing a central estimate or most likely value for the future outcomes. As predictions become increasingly uncertain the further into the future one goes, these ...
Block floating point (BFP) is a method used to provide an arithmetic approaching floating point while using a fixed-point processor. BFP assigns a group of significands (the non-exponent part of the floating-point number) to a single exponent, rather than single significand being assigned its own exponent. BFP can be advantageous to limit space ...
The radar chart is a chart and/or plot that consists of a sequence of equi-angular spokes, called radii, with each spoke representing one of the variables. The data length of a spoke is proportional to the magnitude of the variable for the data point relative to the maximum magnitude of the variable across all data points.
Days payable outstanding (DPO) is an efficiency ratio that measures the average number of days a company takes to pay its suppliers.. The formula for DPO is: = / / where ending A/P is the accounts payable balance at the end of the accounting period being considered and Purchase/day is calculated by dividing the total cost of goods sold per year by 365 days.
An example of waterfall charts. Here, there are 3 total columns called Main Column1, Middle Column, and End Value. The accumulation of successive two intermediate columns from the first total column (Main Column1) as the initial value results in the 2nd total column (Middle Column), and the rest accumulation results in the last total column (End Value) as the final value.
A Nichols plot. The Nichols plot is a plot used in signal processing and control design, named after American engineer Nathaniel B. Nichols. [1] [2] [3] It plots the phase response versus the response magnitude of a transfer function for any given frequency, and as such is useful in characterizing a system's frequency response.