Search results
Results From The WOW.Com Content Network
Shifting in this manner is also used with synchronous manual transmissions, particularly after a clutch failure, to prevent destroying the synchromeshes with the power of the engine. Drivers can shift non-synchronous transmissions without using the clutch by bringing the engine to exactly the right RPM in neutral before attempting to complete a ...
Old-style tank shift. Regular clutch hand Shifter - This is where the shifter is a regular knob either located on the tank, which operates through a linkage to the transmission (tank shifter) or on a lever bolted directly to the top of the transmission (jockey shifter or slap shifter depending on the transmission design) and involves the semi-complex task of foot clutch operation and hand ...
A quickshifter or quick shifter is a device that eliminates the need to use the clutch or throttle when shifting gears on a manual transmission. This can increase the safety and comfort of the vehicle [1] and allow for faster gear shifting (usually shifting in less than 50 milliseconds) and is thus a popular performance enhancement for ...
Underbone and miniature motorcycles often have a three to five-speed foot-shift lever, but the clutch is automatic (usually a centrifugal clutch). This type of clutchless (no manual clutch) transmission still must have the gears shifted manually by the rider, and the system is commonly known as a semi-automatic transmission.
These transmissions can be described as a standard manual transmission with an automated clutch and automated gear shift control, allowing them to operate in the same manner as traditional automatic transmissions. The TCU automatically shifts gears if, for example, the engine is redlined.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...