Search results
Results From The WOW.Com Content Network
The contact area depends on the geometry of the contacting bodies, the load, and the material properties. The contact area between the two parallel cylinders is a narrow rectangle. Two, non-parallel cylinders have an elliptical contact area, unless the cylinders are crossed at 90 degrees, in which case they have a circular contact area.
the area of contact was larger than that predicted by Hertz theory, the area of contact had a non-zero value even when the load was removed, and; there was even strong adhesion if the contacting surfaces were clean and dry. This indicated that adhesive forces were at work.
A Contact Region is a concept in robotics which describes the region between an object and a robot’s end effector. This is used in object manipulation planning, and with the addition of sensors built into the manipulation system, can be used to produce a surface map or contact model of the object being grasped.
Rolling contact between a cylinder and a plane. Particles moving through the contact area from right to left, being strained more and more until local sliding sets in. Rolling contact problems are dynamic problems in which the contacting bodies are continuously moving with respect to each other.
Normal contact stiffness is a physical quantity related to the generalized force displacement behavior of rough surfaces in contact with a rigid body or a second similar rough surface. [ 1 ] [ 2 ] Specifically it is the amount of force per unit displacement required to compress an elastic object in the contact region.
Governed by an interface's Normal contact stiffness, as contact pressure grows, true contact area increases and contact conductance grows (contact resistance becomes smaller). [ 7 ] Since the contact pressure is the most important factor, most studies, correlations and mathematical models for measurement of contact conductance are done as a ...
If there is metal-to-metal contact between electrical contacts, then the electrical contact resistance, or ECR (as opposed to the bulk resistance of the contact metal) is mostly due to constriction of the current through a very small area, the a-spot. For contact spots of radii smaller than the mean free path of electrons , ballistic conduction ...
where and are contact and channel resistances, respectively, / is the channel length/width, is gate insulator capacitance (per unit of area), is carrier mobility, and and are gate-source and drain-source voltages. Therefore, the linear extrapolation of total resistance to the zero channel length provides the contact resistance.