When.com Web Search

  1. Ads

    related to: two port network conversion table

Search results

  1. Results From The WOW.Com Content Network
  2. Two-port network - Wikipedia

    en.wikipedia.org/wiki/Two-port_network

    Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.

  3. Impedance parameters - Wikipedia

    en.wikipedia.org/wiki/Impedance_parameters

    For a one-port network, the Z-matrix reduces to a single element, being the ordinary impedance measured between the two terminals. The Z-parameters are also known as the open circuit parameters because they are measured or calculated by applying current to one port and determining the resulting voltages at all the ports while the undriven ports ...

  4. Equivalent impedance transforms - Wikipedia

    en.wikipedia.org/wiki/Equivalent_impedance...

    A 3-terminal network can also be used as a 2-port. To achieve this, one of the terminals is connected in common to one terminal of both ports. In other words, one terminal has been split into two terminals and the network has effectively been converted to a 4-terminal network.

  5. Admittance parameters - Wikipedia

    en.wikipedia.org/wiki/Admittance_parameters

    Equivalent circuit for an arbitrary two-port admittance matrix. The circuit uses Norton sources with voltage-controlled current sources. Y-equivalent circuit for a reciprocal two-port network. The Y-parameter matrix for the two-port network is probably the most common. In this case the relationship between the port voltages, port currents and ...

  6. Equivalent circuit - Wikipedia

    en.wikipedia.org/wiki/Equivalent_circuit

    These can be represented by simple equivalent circuits of impedances and dependent sources. To be analyzed as a two port network the currents applied to the circuit must satisfy the port condition: the current entering one terminal of a port must be equal to the current leaving the other terminal of the port. [4]

  7. Scattering parameters - Wikipedia

    en.wikipedia.org/wiki/Scattering_parameters

    The Scattering transfer parameters or T-parameters of a 2-port network are expressed by the T-parameter matrix and are closely related to the corresponding S-parameter matrix. However, unlike S parameters, there is no simple physical means to measure the T parameters in a system, sometimes referred to as Youla waves.