Search results
Results From The WOW.Com Content Network
A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [ clarification needed ] stands, and uses tension between the stands as well as compressive force from work rolls [ clarification needed ] to reduce the thickness of steel.
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...
The AC Cobra is an example of a transverse, multi-leaf steel spring suspension that uses the leaf spring as the upper suspension arm. Alternatively, the 1963 Corvette's rear suspension is an example where the transverse leaf spring is used only as a ride spring. In both examples, the leaf spring is centrally mounted, preventing displacement of ...
Multi-link suspension allows the auto designer the ability to incorporate both good ride and good handling in the same vehicle.. In its simplest form, the multi-link suspension is orthogonal—i.e., it is possible to alter one parameter in the suspension at a time without affecting anything else.
Trailing-arm designs in live axle setups often use just two or three links and a Panhard rod to locate the wheel laterally. A trailing arm design can also be used in an independent suspension arrangement. Each wheel hub is located only by a large, roughly triangular arm that pivots at one point, ahead of the wheel. Seen from the side, this arm ...
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.