Search results
Results From The WOW.Com Content Network
A street lamp mounted on a bracket and column A high pressure sodium street light fixture. Street light interference, sometimes called high voltage syndrome, is the claimed ability of individuals to turn street lights or outside building security lights on or off when passing near them. [1]
In visual perception, flicker is a human-visible change in luminance of an illuminated surface or light source which can be due to fluctuations of the light source itself, or due to external causes such as due to rapid fluctuations in the voltage of the power supply (power-line flicker) or incompatibility with an external dimmer.
The advent of miniature lights found the adaptation of twinkle bulbs as flasher bulbs, which interrupt the entire series circuit of anywhere from 10 to 50 bulbs when powered from 120-volt mains electricity (in North America). These are easily recognizable by their red tips on an otherwise unpainted clear white bulb, and are available in the ...
Centennial Bulb in fire station 6. Several reasons have been cited for the bulb's extensive lifespan. Its continuous operation has largely eliminated the stresses associated with turning a light bulb on and off, the act of which causes the temperature of the bulb to increase and decrease.
New lighting systems have not used magnetic ballasts since the turn of the century, however some older installations still remain. Fluorescent lamps with magnetic ballasts flicker at a normally unnoticeable frequency of 100 or 120 Hz (twice of the utility frequency; the lamp is lit on both the positive and negative half-wave of a cycle).
Flicker at power frequency is more noticeable in the peripheral vision than it is when viewed directly. Near the end of life, fluorescent lamps can start flickering at a frequency lower than the power frequency. This is due to instability in the negative resistance of arc discharge, [74] which can be from a bad lamp or ballast or poor connection.
Two ways of doing this are described in the ballast section below. The problem of flickering exists only when using the bulb in combination with magnetic ballast (electronic ballasts produce flicker-free light). HMI bulbs (running with magnetic ballast) present an inherent problem of possibly producing light on film or video with a noticeable ...
The requirements of a flicker measurement equipment are defined in the international electro-technical standard IEC 61000-4-15. [2]A flickermeter is composed of several function blocks which simulate a 230 V/60 W or a 120 V/60 W incandescent lamp (reference lamp) and the human perception system (eye-brain model).