Ads
related to: flashing material for brick veneer
Search results
Results From The WOW.Com Content Network
In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
In building construction, weeps are typically found in a masonry veneer or cavity wall, just above the flashing. The cavity serves as a way to drain this water back out through the weep holes. The weep holes allow wind to create an air stream through the cavity. The stream removes evaporated water from the cavity to the outside.
Reglet detail. A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof.It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration.
A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A multiple-wythe masonry wall may be composed of a single type of masonry unit layered to increase its thickness and structural strength, or different masonry units chosen by function, such as an economical concrete block serving a structural purpose ...
A historic brick building in Germany covered with EIFS on the right side. Exterior insulation and finish system (EIFS) is a general class of non-load bearing building cladding systems that provides exterior walls with an insulated, water-resistant, finished surface in an integrated composite material system.