Search results
Results From The WOW.Com Content Network
Tree taper is the degree to which a tree's stem or bole decreases in diameter as a function of height above ground. Within Forestry and for the purposes of timber production, trees with a high degree of taper are said to have poor form, while those with low taper have good form. The opposite is the case for open-grown amenity trees.
The joint is formed by cutting opposing tapered ends on each member which are then fitted together. When working with wood, this gives better long grain to long grain gluing surface, which yields a stronger joint than would be achieved with a simple butt joint. The tapers are generally cut at an angle between 1:8 to 1:10.
Sheet metal screws make excellent fasteners for attaching metal hardware to wood because the fully threaded shank provides good retention in wood. Twinfast screw A Twinfast screw is a type of screw with two threads (i.e. a twin-start screw ), so that it can be driven twice as fast as a normal (i.e. single-start) screw with the same pitch. [ 4 ]
The President Tree (Sequoiadendron giganteum) [3] was measured in 2012 to have a trunk volume of 54,000 cubic feet (1,500 m 3) of wood and a branch volume of 9,000 cubic feet (250 m 3) of wood in the branches. In this giant tree the branch volume was only 16.7% that of the trunk volume.
The adjacent photo also shows several principles of process ductwork. It shows a large baghouse inlet ductwork. The inlet duct is tapered to minimize dust dropout. A shallow taper such at this also reduces pressure losses when changing duct diameters. Note the rectangular duct ring spacing is roughly 2'-6" on center.
Offset. Offset is the perpendicular distance between the axes of hypoid gears or offset face gears. [1] In the adjacent diagram, (a) and (b) are referred to as having an offset below center, while those in (c) and (d) have an offset above center. In determining the direction of offset, it is customary to look at the gear with the pinion at the ...
Both the tool and socket have a slight taper. The contemporary square drive screw has all but replaced the Robertson screw proper and is commonly referred to as a Robertson because it has practically identical drive dimensions and the same colour identification system, but the contemporary square drive socket has parallel sides rather than tapered.
A shim is a thin and often tapered or wedged piece of material, used to fill small gaps or spaces between objects. [1] Shims are typically used in order to support, adjust for better fit, or provide a level surface. Shims may also be used as spacers to fill gaps between parts subject to wear.